WIWA reversible nozzles
- Pressure up to 500 bar for a uniform spray pattern
- With 145 different models, there‘s a nozzle to suit every application
- For the finest paint finishes with the eco-friendly airless spraying process
Description
Quality in the palm of your hand.
With 145 different models, WIWA reversible nozzles offer a wide range of options and are suitable for a wide variety of materials, from low-viscosity to high-viscosity. Nozzle sizes ranging from 0.009 to 0.053 inches or 0.23 to 1.35 mm allow for precise adaptation to any application and ensure a clean, even spray pattern in daily use.
The right nozzle makes a bigger difference than you might think at first glance. Anyone who works with a spray gun quickly realizes that it’s not just about pressure and technique, but above all about using the right, reversible nozzle for the material in question.
As a general rule: The thicker the material, the larger the nozzle opening should be. Small nozzles are suitable for low-viscosity paints or glazes. They allow for fine atomization, ensure an even finish, and prevent unnecessary material waste. If you use a nozzle that’s too large here, the finish will quickly become uneven.
Durable materials and a well-engineered design ensure a long service life and consistent atomization. This allows for efficient material processing and consistently high quality.
Suitable products
Technical Data
Quality in the palm of your hand.
With 145 different models, WIWA reversible nozzles offer a wide range of options and are suitable for a wide variety of materials, from low-viscosity to high-viscosity. Nozzle sizes ranging from 0.009 to 0.053 inches or 0.23 to 1.35 mm allow for precise adaptation to any application and ensure a clean, even spray pattern in daily use.
The right nozzle makes a bigger difference than you might think at first glance. Anyone who works with a spray gun quickly realizes that it’s not just about pressure and technique, but above all about using the right, reversible nozzle for the material in question.
As a general rule: The thicker the material, the larger the nozzle opening should be. Small nozzles are suitable for low-viscosity paints or glazes. They allow for fine atomization, ensure an even finish, and prevent unnecessary material waste. If you use a nozzle that’s too large here, the finish will quickly become uneven.
Durable materials and a well-engineered design ensure a long service life and consistent atomization. This allows for efficient material processing and consistently high quality.
Suitable products
Materials
- Stains
- Clear lacquers
- Oils and greases
- Throat seal liquid
- Thick-film glazes
- Fillers
- Waterborne paints
- Rust protection and micaceous iron oxide paints
- Zinc dust paints
- Zinc primer
- Primer
- Antifoulings
- Epoxies
- Synthetic rubber
- Synthetic resin dispersion
- Micaceous iron ore
- Bitumen
- Glass flake
- Underbody protection
GmbH & Co. KG
Gewerbestrasse 1-3
35633 Lahnau, Germany
Visitor address:
Georg-Ohm-Strasse 12
35633 Lahnau, Germany
